When you set up your rabbit r1 and scan the activation QR code, you may get an error code like “unable to link your account error code: #”. Setup error codes are usually caused by an issue with your internet connection or an issue with your rabbit r1 reading the QR code.
This article provides the information about the different setup error codes and instructions on how to fix them.
How to fix network error codes on rabbit r1
The following error codes are caused by network issues.
- Error code #1 happens when your r1 is connected to a network, but does not have internet.
- Error code #2 is often caused by a weak Wi-Fi signal.
- Error code #3 is caused by an issue with the rabbit activation servers. Wait a few minutes and try again later.
If you receive a network error code, try the following troubleshooting tips.
- Move around. Your r1 may have a weak Wi-Fi or data signal.
- Try a different network. Connect to a different Wi-Fi network, use your phone as a hotspot, or install a SIM card.
- Wait and try again later. Wait a few minutes and try scanning the QR code later.
Tip: Learn how to fix Wi-Fi issues or how to fix mobile internet issues.
How to fix QR error codes on rabbit r1
Error code #4, error code #5, and error code #6 are all caused by issues with your r1 recognizing the activation QR code.
Visit the article with instruction on how to fix QR code activation issues for troubleshooting tips.